Separate names with a comma.
I just want it gone. Its cost me way too much already. CS8 HL with MK electronics (kit by Quadrocopter; assembled by me) 2x Pelican cases 4x...
I'm getting out of MR flying. So everything must go. I'd like to get rid of everything in one bundle, but I'll break it up if I have to. Asking...
I've got a CS8 HL w/ gimbal and video downlink available for work in Alaska. I'm willing to rent it to an experienced pilot, or fly it myself....
Thanks for all the great replies!
I have read many times on this forum that a crash could have been avoided if the pre-flight checklist had not been rushed and/or skipped. So I'm...
I realize this was back in April, so I hope you have solved this by now. If not, I recently set up a Radian gimbal and noticed in the Radian...
Thanks Jason. I was concerned that the radian would not recognize that Ch1 was different than all the other channels. Guess I'll just try it and...
So on a on a Cinestar 3-Axis + 3x radians I would like to set up the tilt axis to be controlled by the throttle stick on the camera controller....
You know, I've never seen one in person. The pictures I see though, look pretty sexy. But then I think about the 40th, or the 100th flight.. are...
That Gryphon frame gives me pause every time I see it. Keep us informed - let us know how you like it.
Thanks Andy. 1. I'll recallibrate the ACC. 2. My understanding was that the Navi board held the compass. I have not installed the Navi board...
Good evening everyone! I just finished my CS8 Heavy Lift from QC build recently (MK stack). I decided to do a couple test flights in a bare...
Thank you everyone for your responses! Based on your responses I'll be leaving it in the default (2-stick) configuration.
No, not the motor safety switch. So whatever this setting is called, what it did was change the motor start sequence. Instead of the default...
Thanks for the thought Steve - but no, that doesn't seem to be it.
A couple weeks ago I had my FlightCtl 2.5 on the bench for first time programming. I ran across a setting that changed the default motor start...
Gary, Thanks for the comments! I think I'll wait till I'm used to the new setup before I add the spring back in. I figured out what I was doing...
So Page 19 of the MC-32 transmitter manual reads: Both the left and the right joystick can be configured for neutralized or non-neutralized...
Cool, thanks for the feedback Jason.
I stumbled across EMI-shielding heat-shrink today. Thought I'd share. http://www.wirecare.com/product.asp?pn=WC02769229 I emailed the wire care...