/dist/images/branding/favicon
Separate names with a comma.
Hi Michael, is your M10 attached via toad in the hole ? Reason for pointing wrong direction on initializing is wrong position of the toad in the...
Hi Charles, I have got one for two month now and it's amazing. The option with the pages you can edit and switch with the joystick- don't know how...
Hello to all, I've got a problem coming up since upgrade to the new firmware ( the beta that makes mimic work ). All is fine - mimic mode+normal...
Hi everybody, I thought about starting a thread to not leave this product so "alone". From my experience there is a demand for having 5-10 cm...
Hi Thomas, you can do it easy with the Movi-Controller. I've set the roll to the iris dial on the controller and can smoothly roll the axis. I...
Hi Mihkel, I´m based in Berlin, Germany and have an M10 to sell. Perfect condition. Comes with Spectrum Remote, a special FPV-Tray for the...
Hi Cliff, welcome to the community. It's sad to hear of your bad start, but I hope the best for your gimbal future. There are a lot of threads...
Hi Andy, It does clarify all. Wow. Thanks a lot for the info. Best Markus
Thanks for the answer ! The only part I don't get is the point about the upgrade of the controller for free with a new firmware when you still...
Hi guys, Nice work - it might sound stupid- but how does mimic work ? Is it a piece of hardware added to my Movi or just a firmware update on my...
Hi Andy, thanks for your reply. You're right - I didn't test that, but it was the same place in my office where I always tune up, and nothing...
Hello everybody, my M15 shows "compass error" in the app. It tunes up without problems, balance is fine and I checked all cables. What's a little...
Hi Derek - sorry for the confusion. I did the test on a M15. And on the M15 it will be impossible to mount the FS7 with the RAW extension unit. So...
What I forgot- I mounted it on the m15.
I've tried to put in the FS7 today. No problem, but it will be difficult to use the FS7 with the RAW or ProRes Extension. The whole construction...
Hi Adam, what you need is the Ninja Plate from freefly and a toad. Then it's easy to connect the Movi and a Steadycam. Best Markus
I don't have a video as well, but from my experience it isn't that difficult to set up. Robert allready points out what I do. I balance the...
Hi Ian, I've had the same problem and found out that it is very important to take the weight off the gimbal during tightening these screws. So...
Hi Austin, thanks for the fast reply. I meant dropping down cause of the weight. I had the impression, that the clamp sits as tight as...
Hi there, has anyone else noticed a minimal movement of the gimbal down the toad on the M15 ? I see a 0,04 inch movement during the day. There is...