/dist/images/branding/favicon
Separate names with a comma.
Graham, i have not hear back from Freefly and we had this unit from day 1 that M10 launched. at this point, it has fair share of usage and we just...
Graham, thanks for the info... i wrote to them already... it is my 2nd time this unit is acting funny. it will balance, but after 30 sec. it...
hi, we have this m10 and it's acting really funny... we have no idea what's going on... and we been working with this unit for awhile... still...
it's really hard to get much of anything on the status of the pre-ordered Mimic... saw some thread talk about getting a shipping notification,...
question, when it said compatible with all Movi units. does it require any other additional hardware upgrades to the existing Movi? or just...
i mount my ECS next to the motor, since i would like to make the signal as clean as possible. the unit is "disassemblealbe" which i can easily...
having trouble to order cables over sea..... what a pain to wait... found a local cable builder, who can help us in a short term... but need...
jose, here are some idea for u to mount it on Ironman... i am using the Ironman as well, but u really need to think some shock demper. for ur...
Mark, we understand the importance of a balanced flyer is. and we tight down the booms very tight so it has very little wiggle room. due to the...
Andy, the reason that the screws are so long is due to that we need to "take apart" the Octo for easy transport. it just simply too big to travel...
ok, guys... i manage to get some photos and get a chance to take apart the shock damper. i think i may found the reason why the video jiggle...
understood.. will do so after tomorrow step into the office... i should take more photos while i can...
hummm... we are curious... if the prop is unbalanced, shouldn't the video continues to experience jello? the part that we r trying to diagnostic...
gustavo, are u suggesting to add more rings? the photo is an illustration, in fact my setup has more rings than it show with the gopro setup....
my experience with A2 is while in a gusty wind, the futaba 14sg allow it to dial the sensitivity of the controller to deal with the wind... it...
i am using the standard Tarot S1000 frame... see photo (not my actual setup, Octo is at office, so i used a most similar photo from web). [ATTACH]...
guys... i know i am no expert, and i don't have all the right terms for what happened... but here is what's going on... the video link attached...
guys, i been flying with a octo for about 3 months and i built it from scratch. I am also obsessed with hang time v.s. battery capacity. but...
totally don't want to take off while copter is spinning, almost crashed before it takes off... not sure about the Movi powered up but disabled......
Gary, so it's looking for forward... so how do we stop that? it's very scary trying to start the blades while it's "spinning"... any thought?...