Hey FF, We always seem to get these micro-wobbles when we fly our M15. Tuning is very firm. Any ideas on what to look for to tune out the wobbles? If you go full size you can really see the effect.
Derek couple of thoughts. Change the o rings? Also if they are vertical descents those are the worst condition for any rotary wing aircraft as you are descending through the turbulent air generated by the props. Sometimes can't be avoided. Unless you can tune it out then correct in post.
Tried that - fresh black set for this flight. Good point. Those micro wobbles are very difficult to correct in post - even DaVinci struggles with them.
Or descending 10-20 degrees off vertical so the copter's not descending into its own rotor-wash -- if that fixes it, then Gary's correct. Andy Forensic Software & sUAV / Drone Analyst : Photographer : Videographer : Pilot (Portland, Oregon, USA): Trees=2, Ground=1, Props=11. The Ground Is The Limit™ ---------- Forensic Drone Analyst : Forensic sUAV Analyst : Forensic Unmanned Aircraft Analyst : Forensic Drone Expert