/dist/images/branding/favicon

M15 "Trigger Guard"

Discussion in 'MōVI M15' started by Chris Herr, Mar 29, 2015.

  1. Chris Herr

    Chris Herr Member

    Joined:
    Jun 20, 2013
    Messages:
    75
    Likes Received:
    15
    I've been running into a problem with the switch placement on the M15, the existing guard stops short of protecting the switch from bumps especially when using a Slingshot where the hard surface of the vest can easily switch the rig off if you're not careful. My first solution was to tape a plastic bottle cap over the switch, but that was far from elegant.

    Here is the "Trigger Guard V1" (Made with a 3D printer) that attaches via existing holes on the roll motor housing.

    Has this happened to anyone else? If there's enough interest, I'd be happy to make a bunch more for people.

    -Chris
     

    Attached Files:

    Ryan Hamelin likes this.
  2. Jon Firestone

    Jon Firestone New Member

    Joined:
    Mar 30, 2014
    Messages:
    10
    Likes Received:
    1
    I've run into this issue on occasion. I'd buy one from you.
     

Share This Page